Troubleshooter - Maxitrol

Batteries + communication

Before you start, check to see if the adapter is connected to the mains. 
Also check if it connected to the LED module. 

1. You will now (re)set the communication code between transmitter and receiver:

    - Press the RESET button on the receiver until a short beep sounds, followed by a long beep.
    - Release the RESET button and then press (within 20 sec) the 'flame low' button on the remote control.
    - After this, you will hear 2 beeps and briefly the sound of a running servo motor.
      The communication code has been successfully set.

1. Are the batteries empty or weak? Replace with 2x AAA (Shown by the indication on the display)